DIY: Camera Shoulder Rest – Part 2

Jun 22, 2009 by Derrick Faw · 3 Comments ·
Filed under: Equipment 

Several people have requested that I give a better explanation of how to construct our Camera Shoulder Rest. It has been several years since I built the device, but I will try to explain the best I can out of memory.

The frame was constructed of flattened steal. I bough a piece with pre-drilled holes. I cut the steal into two pieces, one being the camera arm and the other for the shoulder support. The shoulder support was then bent in a curved shape. Be sure to allow plenty of extra space for the padding to be added later.

The camera arm was then attached to the shoulder support with a nut and bolt. To give added support to the arm, I was able to find a curved bracket and bolted it between the camera arm and shoulder rest. The device is now ready to paint.

The handle was made from a small rubber-handled plastic flashlight. The light head was cut off using a hacksaw. Then with a long bolt and washers it can be fixed to the end of the camera arm.

I purchased some padding from a cloth shop and fashioned it around the shoulder support. Then secured it with needle and thread. Now with some cloth I sewed a sleeve that would fit around the shoulder support. This process proved to be very difficult. In hindsight it may have been easier to fix the padding and sleeve before bending and attaching the shoulder support the camera arm.

To make the design hands free I had to devise a belt system. I used nylon strapping that can be found in most hardware stores or cloth shops. On each end of the shoulder rest I made a loop, similar to a belt loop. After this another strap can be threaded through the loops to act as a belt around the wearers chest. A plastic buckle was used to fastened the belt around the chest. It also allows for easy adjustment. This will hold the camera rest down on the shoulder. To keep it from sliding off and making it a totally hands free design another strap was used. It was attached near the top of the curve of the shoulder support and running diagonally across the back, then attached to the belt strap.

The last step is to fix a method of attaching the camera to the camera arm. I used an extra plate from quick release tripod mount, then with a bolt and wing nut it can be moved and removed easily. I provided a diagram below to hopefully illustrate my design and meanings better.

camperch001

I would like to add that there are also several good camera rest available for purchase for those not wanting to attempt your own model. Use the link below for a nice selection from B&H.

BH Photo Camera RestS-800 Super Pro Shoulder Support

First time on World Wide Angle, you may want to subscribe to our RSS feed. Thanks for visiting!


 

 

Comments

3 Responses to “DIY: Camera Shoulder Rest – Part 2”

Trackbacks

Check out what others are saying about this post...
  1. worldwideangle says:

    New Blog Post: DIY #2: Camera Shoulder Rest – Part 2 http://tinyurl.com/nv74ur

  2. New Blog Post: DIY #2: Camera Shoulder Rest – Part 2 http://tinyurl.com/nv74ur

  3. [...] NOTE: This post has been continued DIY: Camera Shoulder Rest – Part 2 [...]



Speak Your Mind

Tell us what you're thinking...
and oh, if you want a pic to show with your comment, go get a gravatar!